IGnore if Gecko tool is frozes for a momment, just leave everything and depending on what PassCode it is, it will take some time.įor example 0011 code takes about 5 to 10 seconds to break, 5555 PassCode needs about 30 minutes, so 9999 can take more than one hour i think. It should take 1 to 40 min untill software Bruteforces your PassCode. Once iPhone screen starts to show a BIG white OK, Quit Redsnow, and go back to GECKO. Launch RUN.bat and wait until redsn0w finish its job. Launch "Gecko_iPhone_Toolkit.exe, Chose iPhone 4 (GSM) and press BOOT, than OK, than choose firmware we just downloaded (strictly it should be in the same directory as every other file)ĥ. WinRAR archiverĭownload iphone firmware to the same folder. ONLY iPhone 4 (IPHONE3,1) revision is supported !!! mabe later will support 4,2.ĭownload this file and extract it to c:/A folder. Thank you so much.Its tested on iPhone 4 with 7.0.0 - 7.0.4 - 7.1.1 - 7.1.2 iOS versions. I would like to hear you through comments if you have any problems. One thing about the app is that it won’t work with the iOS 7 or later. There are methods to do the same but the Gecko toolkit will help you a lot. Hope that helps! Now you can reset the passcode of your iOS device using Gecko iPhone Toolkit. Install Kodi on iPhone Without Jailbreak (Without Computer) – No XCode, No Mac And it would be much great if you have a backup of your iPhone as you can restore it later.ĭownload xCleaner for iOS 11/10/9 Without Jailbreak – iPhone Storage Cleanerĥ Best Wifi Analyzer for iPhone to Check Network Signal Strength It is a better option according to me as something is better than nothing. Remember, you need to erase your iOS device. Launch iTunes on your Mac or Windows and connect your iPhone or iPad. Download and Play Music and sync your iPhone data and take safe backups. ITunes has lot more advantages for any iOS device. Just Click “ Launch” when redsnow has finished it’s processing. That will open up the Redsnow and it takes a bit time.ħ. A new window will open up and you need to choose the firmware there. Click on “ Boot” option to start the process. The device can be any iOS device from the list of supporting devices given above.Ħ. Connect your iOS Device (iPhone/iPad) to the computer using a USB Cable.ĥ. Launch it after you install the software on your windows computer.Ĥ. Once you finish downloading the app, Install it by following the simple on-screen instructions.ģ. Download Gecko iPhone Toolkit.exe file for your Windows and (.dmg) for your mac from here.Ģ. Recover Your iOS Device Passcode Using Gecko iPhone Toolkitġ. Note: The Tool and This trick is not needed for iOS 7 or above (iPhone 5, iPhone 6s and iPhone 7s, iPad Air 2, etc). The toolkit supports iPhone 3Gs, iPhone 4, iPad 1, iPod Touch 4G, and iPod Touch 3G, and iOS 4.0 to iOS 6.0.0.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |